You are watching: 2004 impala oil pressure sensor location
HelloThe starter does not need to be removed. Check out the diagrams (Below). Please let us know if you need anything else to get the problem fixed. Cheers
Hello, The oil pressure sensor is on the lower left side engine. Check out the diagrams (Below). Please let us know if you need anything else to get the problem fixed.
Thank you for the information. I have 3.9 liter motor in the picture shows the 3.5 liter. On my motor there is a heat shield where it would appear that the oil filter would be in the illustration. Do I have to remove the heat shield to get at the oil sensor? Is there anything beyond that I need to beware of? Thank you get your help
Engine Oil Pressure Sensor and/or Switch Replacement Tools Required J 41712 Oil Pressure Sensor SocketRemoval Procedure If necessary, remove the engine sight shield. Refer to Upper Intake Manifold Sight Shield Replacement. Disconnect the oil pressure sensor electrical connector (4). Using J 41712, remove the oil pressure sensor (706) and washer (707).
Could you please tell me the location of the oil pressure sensor on a 2007 impala 6cyl flex fuel 3.5 thank you
Can you email me an accurate diagram of the oil pressure sensor location on a 2007 chevrolet impala with the 3.9L engine or, at least provide some direction on how to locate? Some illustrations show it on the right side of the top manifold other info I"ve gotten says it could be located at the bottom of the engine near the oil filter.
I Got My First Oil Change On My 2010 Impala Last Week. It Had Approximately 4200 Miles On It When I Went To Have It Changed. The Engine...
I Was Inspecting The Hoses On My Car And I Made My Way To The Air Intake Duct. The Best Way I Can Describe It Is The Pcv-looking Hose That...
See more: Engraved Woodcuts First Emerged Among Artists In Tmaking In The 16Th Century
Air Conditioning Problem2004 Chevy Impala 6 Cyl Wheel Drive Type Unknown Automatic 87,000 Miles Hi, I Recently Took My Car To The...