JavaScript is disabled. Because that a far better experience, please enable JavaScript in your browser prior to proceeding.


You are watching: 2006 nissan altima crank sensor location

Ok i gained a 2006 altima 2.5l and had to change the CPS sensor.. I can not uncover a an excellent DIY so here you go, the damn STEALER want 300.plus to perform this.. Hell v that... Remove the (4) allen head bolts that organize the plastic engine cover. Remove the wait tube that connects the accelerator chamber come air filter box. Pull turn off the valve sheathe breather hose v the air tube. Now place a drop irradiate under the 2 rubber heater hoses (at the firewall on the chauffeurs hand side), glowing the light forward in the direction of the ago side the the block (below the entry runners). To see the crankshaft sensor and also connector, look in between the valve cover and also the throttle chambers (intake runners) ~ above the motorists side, look right down towards the ground… look because that the sensor v a black color wire connector through a green tab top top the side, organized to the engine block v a yellow colored 10mm hex top bolt. Friend will have to view the sensor from this position as friend are following the steps below to remove and also install the crank sensor.
*

*

You will need to push top top the green part of the clip it rotates you here a CLICK. Then just pull it off of the CPS. Mine just pushed in no prob, yet if it is hard try putting a 15mm socket top top your thumb and try again so that wont reduced into your ignorance it will certainly look prefer this when it comes off.
*

Next step is to get the CPS the end of the side of the block, this to be the hardest part for me.. Its a 10mm bolt holding it in, ns took a 2in extension and also reached down and put that on the bolt. Climate took a 4-6in extension and also rachet and also hooked to the currently started 2in and socket and lossen it up.. Now to get the CPS the end of the block friend might have the ability to wiggle it earlier and forth to gain it out, mine ns took part needle nose pliers and grabbed it and pulled the out..
*

*



See more: Remove All Metallic Jewelry Before Working Around Batteries Because :

next come clean connectors and put in brand-new CPS.. Lube increase the brand-new O ring through oil on slide it in the side of the block,,, then get the 10mm bolt v the sensor and also into the block, kinda tricky! and torque it under think it is 8ft pounds mine is snug
*
" target="_blank" class="link link--external" rel="nofollow ugc noopener">If girlfriend would like to Donate a dissension or two to me for this create up for conserving you part cash, i would certainly be greatful... Simply click the attach below.. Thanks....https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=M2CXXRY436BWY