Every car nowadays has one or more oxygen sensor that plug or screw right into the exhaust system and also monitor the lot of oxygen in the exhaust gas. After ~ a while, they wear out and need to it is in replaced. When they\"ve worn out, they space a leading reason in tripping the \"check engine\" light in your vehicle. Replacing oxygen sensors in a Toyota Tacoma is a fairly easy to moderate repair, noted you have the appropriate tools.

You are watching: 2006 toyota tacoma o2 sensor location


Determine i m sorry oxygen sensor you\"re replacing. This may be the most difficult part of the job. Friend may uncover a garage that will certainly scan and diagnose the engine code for you inexpensively or even complimentary of charge. This will identify which bank and also whether upstream or downstream. If you\"re instead of them all, simply be sure to location the exactly ones in the exactly banks. Plenty of Tacomas usage the exact same oxygen sensor up and down stream.


Using the creeper or blanket, crawl under the truck and locate the oxygen sensor you\"re replacing. Situate the plug of the sensor and also use the straight-edged screwdriver to depress the lock and unplug. You may need to use the upholstery device or plastic plug puller or even the straight-edged screw driver to relax the plug native a manufactured drilled hole and also plug affixing the wire to the vehicle. If the sensor you\"re instead of is the upstream one, girlfriend may also need to pull the end a rubber plug, which runs right into the passenger chair floorboard area. If this is the case, you will need to open the passenger next door and also extract the bottom door molding through a Philips screwdrive and also lift the carpet to situate the plug.


Locate the area wherein the oxygen sensor is bolted to the exhaust pipe. Girlfriend will require to identify the condition of the nuts holding it on. It is not unusual for these nuts to deteriorate and need one extractor socket pounded onto them and also loosened with the 3/8-inch ratchet. When the extractor is on securely, they generally break free relatively easy. If you execute not need the extractor socket, merely use a 10 mm socket to remove the nuts.


Remove the oxygen sensor, and be sure to remove the old gasket and replace with a brand-new one. Most new quality oxygen sensors come with them ideal in the box. That is recommended that you usage a 8 by 1.25 re-threader or dice to clean the object on the bolts of the sensor flange come ensure they do not snap when placing on brand-new nuts.

See more: Whats The Square Root Of 196 ? How Do You Simplify Sqrt(196)


Place brand-new gasket onto bolts. Ar sensor on height of brand-new gasket. Change with brand-new 10 mm 8 by 1.25 pitch, and also thread nuts and also lock washers; tighten.


Creeper or blanket Extractor socket set with small hammer (optional) 3/8-inch drive ratchet 3/8-inch journey 10 mm socket Upholstery tool or plastic plug puller Straight-edged screwdriver Philips head screw driver 8 through 1.25 re-threader or dice 2 brand-new 10 mm nuts through 8 by 1.25 thread and also pitch 2 new lock washers 8 mm pitch

Jody L. Campbell spent over 15 years as both a manager and an under-car specialist in the automotive repair industry. Before that, he managed two different restaurants for over 15 years. Campbell began his professional writing job in 2004 with the publication of his an initial book.